Split Mandrel Tapered 3/32″ shank – 5/32″ head diameter – 3/4″ x 1/32″ slot size

Home
Dremel
Dremel Collet/Mandrels/Chuck
Split Mandrel Tapered 3/32″ shank – 5/32″ head diameter – 3/4″ x 1/32″ slot size – 2-3/8″ total length

Split Mandrel Tapered 3/32″ shank – 5/32″ head diameter – 3/4″ x 1/32″ slot size – 2-3/8″ total length

Price:

$4.99

SKU:

A-M22

Shipping:

Calculated at checkout

Product Description

Split mandrel for sanding papers.
2.35mm shaft.

Loading Split Sandpaper Mandrels

Split Sandpaper Mandrels are used with cloth backed paper that comes in various grits. Use the template to cut pieces of the desired grit sandpaper. Slip the notched end into the slot in the mandrel and tightly wind the paper onto the mandrel with the grit side out. Then glue the nal edge of the roll with super glue. Use a double twisted rubber band around the roll of paper to hold it in place while the glue dries. It is important to use this accessory at 12,000 rpm or lower for re ned sanding and smoothing.

Sandpaper or split mandrels have a “split” above the reinforced base allowing the user to wind sandpaper, polishing cloth, or other abrasives around the gap. These mandrels come in straight and tapered styles and are generally used to sand in tight spots. The straight version is good for finishing smooth surfaces while the tapered offers access to undercuts.
Maximum and recommended speeds depend on the type and size of accessory, as well as the mandrel in use. The ratings we publish for our mandrels are based on an 1″ overhang with an accessory that weighs under 1 gram, and is smaller than 1/2″ in diameter. As a general rule, smaller accessories and mandrels can be used at higher speeds than larger accessories and mandrels. It is a good idea to follow the recommendations that come with both the accessory and the mandrel you are using.

Click this link for instructions and a template to load sandpaper on the split mandrel.

Or this one